Fitting a new hitch to your trailer is a job you can do at home with basic workshop tools. Bolting it on is the easy part. Getting a hitch that suits your drawbar and your trailer’s loaded weight, and fixing it with bolts that will hold on the road, matters more.
This guide covers the tools you’ll need, each step of the install and the checks to make before your first tow. It also explains how to tell if your car is approved to tow at all.
What is a trailer hitch?
“Trailer hitch” means two different things depending on where you are. In the US, it usually means the towbar bolted to the back of the car. In Ireland and the UK, it more often means the coupling on the front of the trailer that locks onto the car’s towball.
This guide covers the second one: fitting a hitch to your trailer’s drawbar. Our trailer hitches are made for exactly this, on road trailers, ATV trailers and off-road equipment.
Want a towbar fitted to your car instead? Skip ahead to the section on whether your car can tow.
Tools you’ll need
This job only needs basic workshop tools. Have these to hand before you start:
- Socket set or spanners to suit M12 nuts.
- Torque wrench.
- Drill with HSS metal bits, including a 13mm bit for M12 bolts.
- Tape measure, marker and centre punch.
- G-clamp to hold the hitch while you drill.
- Gloves and safety glasses.
- Cold galvanising or zinc spray for bare metal.
You’ll also need M12 bolts, washers and self-locking nuts if they aren’t supplied with your hitch.
How to install a trailer hitch, step by step
Follow these steps to fit a new hitch to your trailer’s drawbar.
1. Check the hitch suits your trailer.
Measure the drawbar first. Our pressed steel and swivel hitches fit over 50x50mm box section. Then check the hitch’s weight rating is at least the trailer’s fully loaded weight. A 750kg hitch on a trailer that weighs 900kg loaded is a failure waiting to happen.
2. Remove the old hitch.
Undo the bolts, using penetrating oil if they’ve seized, and slide the hitch off. Clean the drawbar with a wire brush and check it for cracks, rust holes or bends. A new hitch won’t fix a weak drawbar, so replace the drawbar first if it’s damaged.
3. Position the new hitch.
Slide it over the drawbar so it sits fully home and straight in line with the trailer. If you’re reusing existing holes, check they line up, because hole spacing varies between models. Clamp it in place.
4. Mark and drill the holes.
Use the hitch’s own mounting holes as a template. Centre punch each mark, drill a small pilot hole, then open it up to 13mm, going straight through both sides of the box section. Spray the bare metal to stop rust setting in.
5. Bolt it on.
Fit M12 high-tensile bolts with washers and self-locking nuts. Use grade 8.8 bolts or above, not whatever is in the shed drawer. Tighten them to the torque figure the manufacturer gives.
6. Test it on the towball.
Lower the hitch onto your car’s 50mm towball and check the latch closes fully and the handle locks down. The trailer should sit roughly level when hitched. If your hitch has a security lock facility, fit the lock now.
7. Recheck after the first trip.
Bolts can settle after the first tow. Check them again after a short run, then make them part of your regular trailer checks.
Can you put a trailer hitch on any car?
No. A car can only tow if the manufacturer has approved it for towing. Check the plate inside the door or under the bonnet, or the handbook, for a maximum towing weight.
If there’s no figure, or it says 0kg, the car isn’t approved and should not be towing.
A few other rules to keep in mind:
- The lowest figure always applies. Your car’s towing limit, the towbar, the hitch and the trailer plate all have ratings. You can only tow up to the lowest of them.
- Check your licence. On a standard B licence in Ireland, you can tow a trailer with a maximum weight of up to 750kg. You can tow a heavier trailer only if the car and trailer together don’t exceed 3,500kg. Beyond that, you need a BE licence.
- Trailers over 750kg need brakes.
Can you tow with an electric car?
Yes, many electric cars can tow, but some can’t tow at all. Check the towing weight in your car’s handbook or on its plate. If there’s no figure, your car isn’t approved to tow.
Bear in mind that towing uses more battery, so you could lose 30 to 50% of your range. Plan your charging stops before you set off.
Road hitch or swivel hitch?
Pressed steel hitches like the TR1000 are E-marked for road use and suit our road legal trailer kits.
Swivel hitches rotate 360 degrees, so if an ATV trailer tips over, the quad isn’t flipped with it. They’re for off-road use only and suit our ATV trailer kits. Building the whole trailer? See our guide on how to choose the right trailer kit.
Need a hand finding the right hitch?
Take a look at our full range of trailer parts.
Not sure which hitch fits? Send us your drawbar size, the loaded weight of your trailer and a photo of your old hitch, and we’ll match it for you.
Contact us and our team will get back to you.