Winter is when trailers take the most punishment. Salted roads, wet yards and weeks parked up are hard on brakes, hubs, tyres and jockey wheels, and most of the damage stays hidden until something seizes.
A seized brake or a collapsed bearing in January costs you far more than an afternoon of checks in November. This guide covers what to check before winter, the parts that are easy to forget, how to store your trailer until spring, and what to replace if something is worn.
Why winter is hard on trailers
Salt is the real enemy. Gritting crews do not hold back. National Highways spreads an average of 126,500 tonnes of salt a year on England’s motorways and major A-roads [1], Northern Ireland uses around 49,200 tonnes in an average winter [2], and councils across Ireland grit national and regional routes from mid-October to the end of April.
Every tonne of it sprays straight up onto your brakes, hubs, suspension and coupling. Salt holds moisture, moisture starts rust, and rust is what seizes moving parts.
After driving on salted roads, hose the trailer down with clean water. Pay particular attention to the underside, brake drums, hubs and coupling, then let it air-dry. Small patches of surface rust can be cleaned back and sealed before they spread. A full clean and check twice a year, in autumn and spring, keeps you on top of it.
How to check trailer brakes before winter
Brakes are the first thing to seize. In both Ireland and the UK, a trailer over 750kg must have brakes. In Ireland, braked light trailers also need a parking brake and a breakaway cable. Salt and damp are hard on all of it, and a trailer that sits for weeks can end up with its brakes stuck on.
What to look for:
- weak braking, or a handbrake that will not hold
- frayed, stiff or rusted brake cables
- a hub that runs hot after a short trip, which means the brakes are binding
If the brake linings are worn thin or soaked with grease or oil, replace the shoes on both wheels of the axle at the same time, so the trailer brakes evenly. Our brake shoe service kits cover common ALKO and Knott sizes, including the ALKO 160x35, ALKO 200x50, ALKO 230x60, Knott 200x50 and Knott 250x40.
Replace stiff or frayed cables at the same time. Our Bowden brake cables include versions with a stainless steel inner wire, such as the ALKO detachable type and the Knott mushroom type.
How to check trailer hubs, bearings and suspension
Salty water works its way into hubs and bearings. Jack each wheel off the ground and spin it. It should turn freely and quietly, with no grinding and no play when you rock it top to bottom. A hub that runs hot can wreck the bearing and the tyre.
If the hub is worn and the wheel needs replacing too, a complete wheel, hub and stub axle set does both jobs in one go, such as this set of two 4.00-8 trailer wheels with hub and stub axle.
Rubber suspension units take a beating too. Look for sagging, cracking, or one side sitting lower than the other. Replacements come in pairs, including 500kg suspension units with 4x100 hubs and 750kg suspension units with 4/100 hubs.
What to check on trailer tyres in winter
Be sure to check the tread, cracks and pressure. The legal minimum tread depth is 1.6mm, but at least 3mm is recommended for grip on wet and icy roads. Check the sidewalls for fine cracking, bulges and hardened rubber, especially on a trailer that has sat outside all year. Check pressures cold and against the load you are carrying. Cold weather lowers tyre pressure, and a soft tyre on a frosty road is a tyre that slides.
If a tyre is finished, replace both on the axle. We stock a wide range of trailer tyres, such as the 20.5x8.00-10 Journey P815 high-speed trailer tyre, along with wheel rims and complete tyre and wheel assemblies. Our guide to trailer tyres at harvest covers tyre checks in more detail.
The parts people forget
- Jockey wheel. It carries the front of the trailer all winter, often on wet or muddy ground. If it is seized or flat, swap it for our 48mm jockey wheel with clamp or the 48mm Al-ko jockey wheel. If the clamp is cracked, fit a 48mm cast clamp HD.
- Brake shoe expanders and cable eyelets. These are small, cheap and quick to seize. Keep a spare ALKO expander, Knott expander, ALKO eyelet connector or Knott eyelet on the shelf.
- Coupling. Grease the lubrication points before winter, and cover the head when the trailer is parked.
- Lights. Days are short, so walk around the trailer with the lights on before every trip.
How to store a trailer over winter
If the trailer will not be used until spring:
- Wash and dry it fully before you park it.
- Park on hard standing, not grass or mud.
- Chock the wheels and leave the handbrake off, so the shoes do not seize to the drums.
- Tilt it slightly so rainwater drains away instead of pooling.
- Move it a short distance every few weeks to stop the tyres developing flat spots.
Parnells stock brake parts, suspension units, jockey wheels, trailer tyres, wheels and complete assemblies, with our own in-house team of wheel and tyre experts to help you find the right part.
Browse our trailer parts and trailer kits, or contact us with your axle or brake make (ALKO or Knott), drum size, or a photo, and we will match the right parts to your trailer.